#
# grach prog 4 !! prog4 wants Xmode..(rcp)
#
#  50 usec baud
# 100 usec delay , not 200usec like other progs so 4.6->4.7ms delay
# if you want imed start, switch waitfor witth syncsec at bottom
#set waitfor 143000
set waitfor 150000
set srate 20000
set freq "5.095e6"
set outamp "4.3dbm"
set sgSin    1
set sgArb    2
set chnArb   1
log -->start h3253 prog4 xmode then omode
arb $sgArb $chnArb clr
config $sgSin 1freq.cfg freq1=$freq1,outamp=$outampSin
#                 xxxxxxxxxxxx
arb $sgArb $chnArb load arbstart      L200
arb $sgArb $chnArb load l4p7ms        L94
arb $sgArb $chnArb load h70msi100ms   H1400 L400 H1 L199
arb $sgArb $chnArb load hp05msi20ms   L200 H1 L199
arb $sgArb $chnArb load l20ms         L400
#
send $sgArb SOURCE1:BURST:STATE OFF
send $sgArb SOURCE1:FUNC ARB
arb $sgArb $chnArb seq grach/prog4.seq
send $sgArb SOURCE1:FUNC:ARB grachp4
config $sgArb arb1_only.cfg srate=$srate,seqnm=grachp4
#
# sequence
#
startsg $sgSin 1 sine  -1
#
waitfor $waitfor .9
#syncsec .9
startsg $sgArb $chnArb seq:grachp4  1500