Antenna

Return to Equipment Page

RX Commands Receiver MAT Protocol [MAT Protocol] cal - turn cal signal on or off [SNAP Commands] caltemp - set noise cal temperatures [SNAP Commands] rx - receiver monitor and control [SNAP Commands] Phase Cal cable - get the cable cal reading [SNAP Commands] pcal - set up/activate pcalr (Mark III rack) [SNAP Commands] Antenna Pointing antenna - direct line to the antenna [SNAP Commands] azeloff - az-el source position offset [SNAP Commands] beam - set beamsize for flux command [SNAP Commands] fivept - five or more point source scan [SNAP Commands] flux - set flux parameters for a source [SNAP Commands] onoff - on-off radiometry [SNAP Commands] onsource - get antenna pointing status [SNAP Commands] radecoff - ra/dec source position offsets [SNAP Commands] source - source name and position [SNAP Commands] track - display antenna tracking information [SNAP Commands] xyoff - x-y source position offset [SNAP Commands] System Temperatures tpi - read back total power integrators, cal off [SNAP Commands] tpical - read total power integrators, cal on [SNAP Commands] tpzero - measure zero levels [SNAP Commands] tsys - compute and display system temps [SNAP Commands] L.O. lo - LO frequencies (Mark III rack) [SNAP Commands] lo - LO frequencies (VLBA rack) [SNAP Commands] upconv - upconverter frequencies (Mark III rack) [SNAP Commands] upconv - upconverter frequencies (VLBA rack) [SNAP Commands]

Return to Equipment Page

Last updated: September 4, 1997