Log for 05/05/12 pm
Observers: BK, SS

System Configuration:

FixedAZ Drift Map Cima new version 1.2.02 (new)
Using: a2010_fixedfrq_may05.gui as save state.

Files: /share/pserverf.sda3/wappdata/wapp.20050512.a2010.****.fits


LST  fits Scan      calscan   Source    Pattern  Start coords. ang  time loop  DecJ off  Notes
_______________________________________________________________________________________________

1008 0001 513269136 513269739 drift57p1 FixedAz  094417+134454  19  600  15

power levels (dB): 0.973 0.922 1.019 0.965 1.096 1.007 0.906 1.073 0.931 0.934 1.091 1.139 1.067 0.952

1018 0002 513269742 513270344
1028 0003 513270347 513270949
1038 0004 513270952 513271554
1048 0005 513271557 513272159
1058 0006 513272162 513272764
1109 0007 513272767 513273369
1119 0008 513273372 513273974
1129 0009 513273977 513274579
1139 0010 513274582 513275184
0011 aborted (we ran out of time)

END LIST: 114940


Notes:
- Tiedowns are active
- We lost time at the start because we got the message "Correlator Configuration changed since last apply, continue?" after clicking "Observe".  
  We ignored the message but then saw no data was being taken.  
  We think the problem was clicking "Configure WAPP ALFA" too fast so that CIMA didn't register the command.  The command does not appear in the CIMA log file, even though
   we are sure we pressed the button.
- Documentation says the normal and test versions of CIMA marked 1.2.02 are the same, and Mikael says to use the normal version.

- BK notes:  When clicking to setup CIMA, make sure the command click are registered in the window before proceeding.  Otherwise the command may not take.
	     Willie Torres reported that our logout did not complete for some reason at the end.