Log for 3/20/05 am            ** see important note at bottom ** 

Observers:  BK, KH

System Configuration:

FixedAZ Drift Map Cima pattern; with "new Fits file each loop" = 1
calibration mode: "loopend", 1sec CalON at the end of each drift segment

Files: /share/pserverf.sda3/wappdata/wapp.20050320.a2010.****.fits

LST  fits Scan      calscan   Source    Pattern  Start coords. ang  time loop  DecJ off  Notes
_____________________________________________________________________________________________________________________

1208 0001 507902640 507903241 drift34p1 FixedAz 120817+080905  19   600  29
1218 0002 507903245 507903847
1228 0003 507903850 507904451
1238 0004 507904455 507905056
1248 0005 507905060 507905662
1258 0006 507905665 507906266
1309 0007 507906270 507906872
1319 0008 507906875 507907476
1329 0009 507907480 507908082
1339 0010 507908085 
WAPP CRASH on file 10. File 10, beam 3 bad.


END LST:  ~13:50:00

Notes:
WAPP(2) ERROR counts don't match for chip 2 error again. 
Multiple tries to restart wapps and flush command did not work.  
Calls to M. Lerner and examiningn the last CAL of file 0010 
showed that beam 3 had died.  J. Hagen recommended call to 
B. Sisk.  W. Torres restarted all WAPP hardware.  
Further "Flush" commands, etc. gave same result, except 
now for all "chips".


Note added:  Bill Sisk replaced half a wapp, showed B. Kent how 
to run diagnostic and find a bad chip.  Replacement module was 
placed in the rack.  Testing completed in the afternoon - 
went fine.  See log050320ptest.