Log for 080430        Observer: Brian Kent

System Configuration: a2010_az360.conf

File:   /share/pserverf.sdb1/wappdata/wapp.20080430.a2010.****.fits
        /share/pserverf.sdb1/wappdata/wapp.20080501.a2010.****.fits

LST  fits   Scan      calscan  Source     Pattern  Start coords. ang  time loop calmode

1344 0022 812100135 812100136  drift3p1   fixAZdr  134425+003630 19  600   99   loopend   power OK  5
                                   warning given:  There are WAPP channels with too much power (7.445 > 1.4)!
                                   beam 0 pol B is kinda flaky.  Spikes occuring and large flucuations in power
1354 0023 812100137 812100138
1404 0024 812100139 812200001
1414 0000 812200002 812200003
1424 0001 812200004 812200005
1435 0002 812200006 812200007
1445 0003 812200008 812200009   
1455 0004 812200010 812200011
1505 0005 812200012 812200013  Power OK (except for Beam 0 Pol B)  
                                  Ed Cruz reports alarm on Beam 0 Pol B.  Same as previous night
1515 0006 812200014 812200015  
1525 0007 812200016 812200017
1535 0008 812200018 812200019
1545 0009 812200020 812200021 
1555 0010 812200022 812200023   
1606 0011 812200024 812200025   Power OK (except for Beam 0 Pol B)
1616 0012 812200026 812200027
1627 0013 812200028 812200029  
1637 0014 812200030 812200031   Power OK (except for Beam 0 Pol B)
1647 0015 Abort


End LST: 1647

Notes:

Beam 0 Pol B continues to fluctuate as in previous runs.  Electronics group is aware of the problem.
TOGS cal run at the end.