
| Block | A2010 observing log | Cima log | Scan list | Comment |
|---|---|---|---|---|
| 06.12.14p | log061214p | cimalog | fitsfiles | TOGS at end. Beam 1B off during entire scan (bad power) |
| 06.12.12p | log061212p | cimalog | fitsfiles | TOGS at end. All ok. |
| 06.12.11p | log061211p | cimalog | fitsfiles | TOGS at end. All ok. |
| 06.12.10p | log061210p | cimalog | fitsfiles | TOGS at end. GPS in one scan. All ok. | 06.12.09p | log061209p | cimalog | fitsfiles | TOGS at end. GPS in two scans. Problems with one FITS (same problem as 06.11.01, see log) - fixed on 2006.12.10. |
| 06.12.08p | log061208p | cimalog | fitsfiles | TOGS at end. RFI at 1380MHz. |
| 06.12.07p | log061207p | cimalog | fitsfiles | TOGS at end. No problems. No unusual RFI. |
| 06.12.06p | log061206p | cimalog | fitsfiles | TOGS at end. First three drifts may have wrong position information in header (see log). Some intermittent RFI bursts at ~1400 MHz (GPS test?). |
| 06.12.02 | log061202 | cimalog | fitsfiles | WAPP problems; lost an hour. See log. TOGS at end. |
| 06.12.01 | log061201 | cimalog | fitsfiles | TOGS at end. |
| 06.11.30 | log061130 | cimalog | fitsfiles | TOGS at end. Tiedowns disabled. |
| 06.11.29 | log061129 | cimalog | fitsfiles | NO successful TOGS -- WAPP failure twice during TOGS at end of run. WAPP failure twice near start of run. Tiedowns disabled. |
| 06.11.28 | log061128 | cimalog | fitsfiles | TOGS run at end only. WAPPs failure at very end of run, during last drift cal, before TOGS. |
| 06.11.27 | log061127 | cimalog | fitsfiles | TOGS run at end only. All ok. |
| 06.11.26 | log061126 | cimalog | fitsfiles | TOGS run at end only. Tiedowns disabled during lightning. All ok. |
| 06.11.25 | log061125 | cimalog | fitsfiles | TOGS run at start and end. All ok. |
| 06.11.24 | log061124 | cimalog | fitsfiles | TOGS run at start and end. All ok. |
| 06.11.23 | log061123 | cimalog | fitsfiles | TOGS run at start and end. All ok. |
| 06.11.22 | log061122 | cimalog | fitsfiles | TOGS run at start and end. Beam 1 Pol B now fine (system was warmed up since last run). |
| 06.11.16 | log061116 | cimalog | fitsfiles | TOGS run at start and end. Major WAPP errors (lost an hour) near start. Power in 1B very very low. |
| 06.11.08 | log061108 | cimalog | fitsfiles | TOGS run at start and end. Note beam 1B is "warm". |
| 06.11.07 | log061107 | cimalog | fitsfiles | TOGS run at start and end. All ok. |
| 06.11.06 | log061106 | cimalog | fitsfiles | TOGS run at start and end. Pair of WAPPS error twice (see log). |
| 06.11.05 | log061105 | cimalog | fitsfiles | TOGS run at start and end. All ok. |
| 06.11.03 | log061103 | cimalog | fitsfiles | TOGS run at start and end. All ok. |
| 06.11.02 | log061102 | cimalog | fitsfiles | TOGS run at start and end. All ok. |
| 06.11.01 | log061101 | cimalog | fitsfiles | TOGS run at start and end. RFI at 1380 MHz weak but present all time. Problems with beam 6, 1 fits only - see
log for details. WAPP software updates - see log. Note added: On this date and several days thereafter, observant observers noticed extra noise in Beam 1.0; see Phil's notes on the problem. |
| 06.10.31 | log061031 | cimalog | fitsfiles | TOGS run at start and end. All observations Ok. |
| 06.10.30 | log061030 | cimalog | fitsfiles | WAPPS failure at beginning of TOGS. Restarted and ran OK. Operator ran start_gpib again. All observations Ok. Noticed RFI from 1400 to 1405 MHz in last drift. |
| 06.10.19 | log061019 | cimalog | fitsfiles | TOGS run at start only. Connection lost at the end of the run. Need to check files 9-18. Note: Az enc failure |
| 06.10.18 | log061018 | no cimalog | no fitsfiles | No observing due to unscheduled maintenance. See log for details. |
| 06.10.17 | log061017 | cimalog | fitsfiles | TOGS run at start and end. All OK. Note: Az enc failure |
| 06.10.16 | log061016 | cimalog | fitsfiles | TOGS run at start and end. Strong RFI from Puntas Salinas between LST 21:35 - 2:09, otherwise okay. Note: Az enc failure |
| 06.10.15 | log061015 | cimalog | fitsfiles | Time only allocated for TOGS at start. All okay. Note: Az enc failure |
| 06.10.14 | log061014 | cimalog | fitsfiles | Time only allocated for TOGS at start. All okay. Note: Az enc failure |
| 06.10.13 | log061013 | cimalog | fitsfiles | Time only allocated for TOGS at start. All okay. |
| 06.10.11 | log061011 | cimalog | fitsfiles | Time only allocated for TOGS at start. All okay. |
| 06.10.10 | log061010 | cimalog | fitsfiles | Time only allocated for TOGS at start. All okay. |
| 06.10.09 | log061009 | cimalog | fitsfiles | Time only allocated for TOGS at start. All okay. |
| 06.10.08 | log061008 | cimalog | fitsfiles | Time only allocated for TOGS at start. All okay. |
| 06.10.07 | log061007 | cimalog | fitsfiles | TOGS run at start and end. All okay. |
| 06.10.06 | log061006 | cimalog | fitsfiles | TOGS run at start and end. All okay. |
| 06.10.01 | log061001 | cimalog | fitsfiles | TOGS run at end only. All okay. |
| 06.09.29 | log060929 | cimalog | fitsfiles | TOGS run at start (may not be good - see log) and end. WAPP error three times (see log). |
| 06.09.28 | log060928 | cimalog | fitsfiles | TOGS run at start and end. Nothing to report. |
| 06.09.27 | log060927 | cimalog | fitsfiles | TOGS run at start and end. All okay. |
| 06.09.26 | log060926 | cimalog | fitsfiles | TOGS run at start and end. All okay. |
| 06.09.19 | log060919 | cimalog | fitsfiles | TOGS run at start only. No problems. Last run for this set. |
| 06.09.18 | log060918 | cimalog | fitsfiles | TOGS run at start only. No problems. |
| 06.09.17 | log060917 | cimalog | fitsfiles | TOGS run at start only. No problems. |
| 06.09.16 | log060916 | cimalog | fitsfiles | TOGS run at start only. No problems. |
| 06.09.15 | log060915 | cimalog | fitsfiles | TOGS run at start only. No problems. |
| 06.09.14 | log060914 | cimalog | fitsfiles | TOGS run at start only. No problems (5B behaved well). |
| 06.09.13 | log060913 | cimalog | fitsfiles | TOGS run at start only. Beam 5B power levels bit noisy but in blue range. |
| 06.09.12 | log060912 | cimalog | fitsfiles | TOGS run at start only. Beam 5B power levels unstable early, rose to 1.5 mid-run. |
| 06.09.11 | log060911 | cimalog | fitsfiles | TOGS run at start only. No problems tonight. |
| 06.09.10 | log060910 | cimalog | fitsfiles | TOGS run at start only. No problems tonight. |
| 06.09.09 | log060909 | cimalog | fitsfiles | TOGS run at start only. No problems tonight. |
| 06.09.08 | log060908 | cimalog | fitsfiles | TOGS run at start only. Beam 5B acting up again; see log for details. |
| 06.09.07 | log060907 | cimalog | fitsfiles | TOGS run at start only. All OK.) |
| 06.09.06 | log060906 | cimalog | fitsfiles | TOGS run at start only. One WAPP error near end (calibration will need to be split) |
| 06.09.05 | log060905 | cimalog | fitsfiles | TOGS run at start and end. All okay. |
| 06.09.04 | log060904 | cimalog | fitsfiles | TOGS run at start and end. Disturbing RFI in one scan. |
| 06.09.03 | log060903 | cimalog | fitsfiles | TOGS run at start and end; one scan aborted due to WAPPs error. |
| 06.09.02 | log060902 | cimalog | fitsfiles | TOGS run at start and end; Beam 5B higher power level in some scans (see log). |
| 06.09.01 | log060901 | cimalog | fitsfiles | TOGS run at start and end; no problems. |
| 06.08.31 | log060831 | cimalog | fitsfiles | TOGS run at start and end; alfadatawin would not refresh in Ithaca or at AO. Problem reported to operator and M. Lerner |
| 06.08.25 | log060825 | cimalog | fitsfiles | TOGS run at start and end; no problems. |
| 06.08.24 | log060824 | cimalog | fitsfiles | TOGS run at start and end; no problems. |
| 06.08.23 | log060823 | cimalog | fitsfiles | TOGS run at start and end; no problems. |
| 06.08.22 | log060822 | cimalog | fitsfiles | TOGS was run, but unsuccessfully, at beginning. TOGS run at end ok. Other than initial TOGS hiccup, no problems. |
| 06.08.20 | log060820 | cimalog | fitsfiles | TOGS was not run at beginning. TOGS run at end ok. Intermittent problems with laser ranging (see log). |
| 06.08.19 | log060819 | cimalog | fitsfiles | Ran TOGS at start and end; no problems. |
| 06.08.18 | log060818 | cimalog | fitsfiles | Ran TOGS at start and end; no problems. |
| 06.08.17 | log060817 | cimalog | fitsfiles | Ran TOGS at start and end; one scan lost to WAPP/network issues (see log). |
| 06.08.16 | log060816 | cimalog | fitsfiles | Unable to run TOGS cal at start; ran at end. No problems. |
| 06.08.15 | log060815 | cimalog | fitsfiles | TOGS at start/end. No problems. |
| 06.08.14 | log060814 | cimalog | fitsfiles | TOGS at start/end. There were problems using dataview so VNC wasn't used. WAPP error midrun. |
| 06.08.13 | log060813 | cimalog | fitsfiles | TOGS at start only. No problems. |
| 06.08.12 | log060812 | cimalog | fitsfiles | TOGS at start/end. No problems. Boring is good. |
| 06.08.11 | log060811 | cimalog | fitsfiles | We kick off the fall season! TOGS at start/end. First session with VNC worked fine. RFI spike in two beams - see note. |